HP 5800 Series User Manual

124
Field Description
IS-IS Level-1 Traffic Engineering Status TE state of Level-1 router
IS-IS Level-2 Traffic Engineering Status TE state of Level-2 router
display mpls lsp bfd te
Description
Use the display mpls lsp bfd te command to display the BFD information for MPLS TE tunnels.
Syntax
display mpls lsp bfd [ te tunnel tunnel-number ] [ | { begin | exclude | include } regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
tunnel tunnel-number: Displays the BFD information of the specified MPLS TE tunnel. tunnel-number is the
tunnel interface number.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see the Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, which is a case-sensitive string of 1 to 256 characters.
Examples
# Display the BFD information of the MPLS TE tunnel using tunnel interface Tunnel 0.
<Sysname> display mpls lsp bfd te Tunnel 0
MPLS BFD Session(s) Information
-----------------------------------------------------------------------------
FEC : Tunnel0 Type : TE Tunnel
Local Discr : 3 Remote Discr : 3
Tunnel ID : 0xd2009 NextHop : ----
Session State : Up Source IP : 1.1.1.1
Session Role : Active
Total Session Num: 1
Table 48 Command output
Field Description
Type Type of the tunnel detected by BFD, which can be LSP or TE Tunnel

HP 5800 Series Specifications

General

MAC Address Table Size	32, 000 entries
Uplink Ports	2 or 4 SFP+ 10GbE ports
Routing Protocol	BGP, IS-IS
Input Voltage	100-240 VAC
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 95% (noncondensing)
PoE	Optional
Power Supply	Redundant power supply (optional)