228
• Sites of a VPLS instance use natural numbers as the site IDs. In a VPN, each site ID must be unique.
• For a VPLS instance, you are not allowed to execute the site command repeatedly.
Syntax
site site-id [ range site-range ] [ default-offset { 0 | 1 } ]
undo site site-id
View
VSI BGP view
Default level
2: System level
Parameters
site-id: Specifies the ID of a site of the VPLS instance. The valid values ranges from 0 to 32.
range site-range: Specifies the site range on a PE. The site-range parameter is the total number of sites of
a VPLS instance. The value ranges from 1 to 33 and the default is 10.
default-offset { 0 | 1 }: Specifies the default initial CE offset. It can be 0 or 1 and defaults to 0.
Examples
# Create sites for VPLS instance aaa and set the site range to 20.
<Sysname> system-view
[Sysname] vsi aaa
[Sysname-vsi-aaa] pwsignal bgp
[Sysname-vsi-aaa-bgp] site 1 range 20
tnl-policy
Description
Use the tnl-policy command to specify a tunneling policy for a VPLS instance.
Use the undo tnl-policy command to remove the configuration.
By default, if you do not specify a tunneling policy for a VPLS instance, the default tunneling policy is
used. The default tunneling policy selects only one tunnel in this order: LSP tunnel, CR-LSP tunnel.
If you specify a tunneling policy name, but the tunneling policy is not configured, the default tunneling
policy is used.
For how to configure a tunneling policy, see the chapter “MPLS L3VPN configuration.”
Related commands: tunnel policy.
Syntax
tnl-policy tunnel-policy-name
undo tnl-policy
View
VSI view
Default level
2: System level
To Next Page
Loading...
