HP 5800 Series

188
Syntax
mpls te route-pinning
undo mpls te route-pinning
View
Tunnel interface view
Default level
2: System level
Parameters
None
Examples
# Enable route pinning.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] mpls te route-pinning
mpls te signal-protocol
Description
Use the mpls te signal-protocol command to configure the signaling protocol for MPLS TE tunnel
establishment.
The default signaling protocol for MPLS TE tunnel establishment is RSVP-TE.
CAUTION:
To use RSVP-TE as the signaling protocol for setting up the MPLS TE tunnel, you must enable both MPLS
TE and RSVP-TE on the interface for the tunnel to use.
Syntax
mpls te signal-protocol { crldp | rsvp-te | static }
View
Tunnel interface view
Default level
2: System level
Parameters
rsvp-te: Sets the signaling protocol for MPLS TE tunnel establishment to RSVP-TE.
crldp: Sets the signaling protocol for MPLS TE tunnel establishment to CR-LDP. This keyword is not
supported on HP 5820X&5800 series.
static: Sets up the tunnel using a static CR-LSP.
Examples
# Adopt RSVP-TE as the signaling protocol for establishing MPLS TE tunnel 0.
<Sysname> system-view
[Sysname] interface tunnel 0