HP 5800 Series User Manual

246
Tunnel ID : 0x220020
Table 98 Command output
Field Description
VC ID Remote VC ID
VC State Status of the VC
Destination Destination IP address
Client Intf Interface connected with the CE
Local Group ID
Local VC group ID, used for the L2VPN VC FEC TLV
field of LDP messages
Remote Group ID
Remote VC group ID, used for the L2VPN VC FEC
TLV field of LDP messages
Tunnel Policy Tunnel policy configured
Tunnel Type Type of the tunnel
Tunnel ID ID of the tunnel
# Display information about Martini VCs received from the remote peer.
<Sysname> display mpls l2vc remote-info
total remote ldp vc : 1
Transport Group Peer Remote Remote C Remote
VC ID ID Addr Encap VC Label Bit MTU
100 0 3.3.3.9 ethernet 1025 0 1500
Table 99 Command output
Field Description
total remote ldp vc Total number of remote LDP VCs.
Transport VC ID Remote VC ID.
Group ID
Remote VC group ID, used for the L2VPN VC FEC
TLV field of LDP messages.
Peer Addr IP address of the peer.
Remote Encap Encapsulation type of the remote interface.
C Bit
Whether the control word function is enabled or not.
0 means disabled and 1 means enabled.
Remote MTU MTU of the remote interface.
display mpls l2vpn
Description
Use the display mpls l2vpn command to display information about L2VPNs configured on a PE.
If you do not specify a VPN, the command displays information about all L2VPNs.

HP 5800 Series Specifications

General

MAC Address Table Size	32, 000 entries
Uplink Ports	2 or 4 SFP+ 10GbE ports
Routing Protocol	BGP, IS-IS
Input Voltage	100-240 VAC
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 95% (noncondensing)
PoE	Optional
Power Supply	Redundant power supply (optional)