HP 5800 Series

106
Syntax
remote-ip ip-address
undo remote-ip
View
MPLS LDP remote peer view
Default level
2: System level
Parameters
ip-address: Specifies the remote peer IP address.
Examples
# Configure the remote peer IP address as 3.3.3.3.
<Sysname> system-view
[Sysname] mpls ldp remote-peer BJI
[Sysname-mpls-ldp-remote-bji] remote-ip 3.3.3.3
remote-ip bfd
Description
Use the remote-ip bfd command to enable BFD for an LDP remote peer.
Use the undo remote-ip bfd command to disable BFD for an LDP remote peer.
By default, BFD is not enabled for detecting the reachability to a remote peer.
Syntax
remote-ip bfd
undo remote-ip bfd
View
MPLS LDP remote peer view
Default level
2: System level
Parameters
None
Examples
# Configure a remote peer named bji and enable BFD for it.
<Sysname> system-view
[Sysname] mpls ldp remote-peer bji
[Sysname-mpls-ldp-remote-bji] remote-ip bfd
reset mpls ldp
Description
Use the reset mpls ldp command to reset LDP sessions.