HP 5800 Series

199
VPLS configuration commands
NOTE:
The HP 5820X switch series do not support VPLS.
description
Description
Use the description command to set a description for a VPLS instance.
Use the undo description command to remove the configuration.
By default, no description is set for a VPLS instance.
Syntax
description text
undo description
View
VSI view
Default level
2: System level
Parameters
text: Describes a VPLS instance, which is a string of 1 to 80 characters.
Examples
# Set the description of VPLS instance aaa to Aaa_Technologies_Co._Ltd..
<Sysname> system-view
[Sysname] vsi aaa
[Sysname-vsi-aaa] description Aaa_Technologies_Co._Ltd.
display bgp vpls
Description
Use the display bgp vpls command to display the VPLS information in a BGP routing table.
Syntax
display bgp vpls { all | group [ group-name ] | peer [ [ ip-address ] verbose ] | route-distinguisher route-
distinguisher [ site-id site-id [ label-offset label-offset ] ] } [ | { begin | exclude | include } regular-
expression ]
View
Any view