140
display mpls static-cr-lsp
Description
Use the display mpls static-cr-lsp command to display information about static CR-LSPs.
Syntax
display mpls static-cr-lsp [ lsp-name lsp-name ] [ { include | exclude } ip-address prefix-length ] [ verbose ]
[ | { begin | exclude | include } regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
lsp-name lsp-name: Specifies the label switched path name comprising 1 to 15 characters.
include: Displays only CR-LSPs with the destination IP address specified by the ip-address prefix-length
parameters.
exclude: Displays only CR-LSPs with destination IP addresses other than the one specified by the ip-
address prefix-length parameters.
ip-address: Specifies the IP address of the FEC.
prefix-length: Specifies the IP address prefix length, ranging from 0 to 32.
verbose: Displays detailed information.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see the Fundamentals Configuration Guide.
• begin: Displays the first line that matches the specified regular expression and all lines that follow.
• exclude: Displays all lines that do not match the specified regular expression.
• include: Displays all lines that match the specified regular expression.
• regular-expression: Specifies a regular expression, which is a case-sensitive string of 1 to 256
characters.
Examples
# Display brief information about all static CR-LSPs.
<Sysname> display mpls static-cr-lsp
total statics-cr-lsp : 1
Name FEC I/O Label I/O If State
Tunnel0 3.3.3.9/32 NULL/100 -/Vlan1 Down
Table 59 Command output
Field Description
Name Static CR-LSP name
FEC FEC associated with the destination IP address of LSP
I/O Label Incoming/outgoing label
I/O If Incoming/outgoing interface
To Next Page
Loading...
