EasyManuals Logo

HP 5800 Series User Manual

HP 5800 Series
396 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #189 background imageLoading...
Page #189 background image
180
Use the undo mpls te link administrative group command to restore the default.
The default link administrative group attribute is 0x00000000.
The interface properties are propagated globally. They are used for path selection at the tunnel ingress.
Related commands: mpls te affinity property.
Syntax
mpls te link administrative group value
undo mpls te link administrative group
View
Interface view
Default level
2: System level
Parameters
value: Specifies the link administrative group attribute, ranging from 0x00000000 to 0xFFFFFFFF. It is a
set of 32 link properties. Each bit represents a property with a value of 0 or 1. By ANDing the
administrative group attribute bits with the link affinity attribute bits of an MPLS TE tunnel, MPLS TE
identifies the properties of the links that the MPLS TE tunnel can use.
Examples
# Assign VLAN-interface 1 the link administrative group attribute of 0x00000101.
<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] mpls te link administrative group 101
mpls te loop-detection
Description
Use the mpls te loop-detection command to configure the node to perform loop detection when setting up
the MPLS TE tunnel.
Use the undo mpls te loop-detection command to disable loop detection.
Loop detection is disabled by default.
Syntax
mpls te loop-detection
undo mpls te loop-detection
View
Tunnel interface view
Default level
2: System level
Parameters
None

Table of Contents

Other manuals for HP 5800 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP 5800 Series and is the answer not in the manual?

HP 5800 Series Specifications

General IconGeneral
MAC Address Table Size32, 000 entries
Uplink Ports2 or 4 SFP+ 10GbE ports
Routing ProtocolBGP, IS-IS
Input Voltage100-240 VAC
Operating Temperature0°C to 45°C
Operating Humidity10% to 95% (noncondensing)
PoEOptional
Power SupplyRedundant power supply (optional)

Related product manuals