HP 5800 Series

190
Parameters
second: Specifies the interval for re-establishing the tunnel, ranging from 1 to 4,294,967,295 seconds.
Examples
# Set the interval for re-establishing tunnel 0 to 20 seconds.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] mpls te timer retry 20
mpls te tunnel-id
Description
Use the mpls te tunnel-id command to configure the tunnel ID.
Configure the tunnel ID before issuing the mpls te commit command for the first time. Otherwise, the
tunnel cannot be created.
Once configured, a tunnel ID cannot be removed. To change a tunnel ID, remove the tunnel and then
reconfigure the tunnel, giving it a new tunnel ID.
Syntax
mpls te tunnel-id tunnel-id
View
Tunnel interface view
Default level
2: System level
Parameters
tunnel-id: Specifies the tunnel ID. The value ranges from 1 to 1024.
Examples
# Configure the tunnel ID as 100.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] mpls te tunnel-id 100
mpls te vpn-binding
Description
Use the mpls te vpn-binding command to define the traffic that can travel the MPLS TE tunnel.
Use the undo mpls te vpn-binding command to restore the default.
By default, no restriction is defined about what traffic can travel down a TE tunnel.
Syntax
mpls te vpn-binding { acl acl-number | vpn-instance vpn-instance-name }
undo mpls te vpn-binding