HP 5800 Series

368
Parameters
group-name: Specifies the name of the peer group, which is a case-sensitive string of 1 to 47 characters.
ip-address: Specifies the IP address of the peer.
value: Specifies the preference value to be specified, ranging from 0 to 65,535.
Examples
# In BGP-VPNv6 subaddress family view, set the preference value for the routes received from peer
131.10 8 .1.1 t o 5 0 .
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family vpnv6
[Sysname-bgp-af-vpnv6] peer 131.108.1.1 preferred-value 50
peer public-as-only (BGP-VPN6 subaddress family view)
Description
Use the peer public-as-only command to make outbound BGP updates carry no private AS numbers.
Use the undo peer public-as-only command to make outbound BGP updates carry private AS numbers.
By default, a BGP update carries private AS numbers.
If a BGP update to be sent carries any public AS number, this command does not take effect. The private
AS number ranges from 64,512 to 65,535.
Syntax
In BGP-VPNv4 subaddress family view:
peer { group-name | ip-address } public-as-only
undo peer { group-name | ip-address } public-as-only
In BGP-VPNv6 subaddress family view:
peer ip-address public-as-only
undo peer ip-address public-as-only
View
BGP-VPNv6 subaddress family view
Default level
2: System level
Parameters
group-name: Specifies the name of the peer group, which is a case-sensitive string of 1 to 47 characters.
ip-address: Specifies the IP address of the peer.
Examples
# In BGP-VPNv6 subaddress family view, configure the device to exclude private AS numbers from the
BGP updates to be sent to the peer 1.1.1.1.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family vpnv6