HP 5800 Series User Manual

89
[Sysname-mpls-ldp] graceful-restart timer neighbor-liveness 100
graceful-restart timer reconnect
Description
Use the graceful-restart timer reconnect command to set the FT reconnect time.
Use the undo graceful-restart timer reconnect command to restore the default.
By default, the FT reconnect time is 300 seconds.
The FT reconnect time refers to the maximum time that the stale state flag is preserved by the LSR after the
TCP connection fails.
Modifying the FT reconnect time will cause all LDP sessions and all LSPs based on the sessions to be
removed and then reestablished.
Syntax
graceful-restart timer reconnect timer
undo graceful-restart timer reconnect
View
MPLS LDP view
Default level
2: System level
Parameters
timer: Specifies the FT reconnect time, ranging from 60 to 300 seconds.
Examples
# Set the FT reconnect time to 100 seconds.
<Sysname> system-view
[Sysname] mpls ldp
[Sysname-mpls-ldp] graceful-restart timer reconnect 100
graceful-restart timer recovery
Description
Use the graceful-restart timer recovery command to set the LDP recovery time.
Use the undo graceful-restart timer recovery command to restore the default.
By default, the LDP recovery time is 300 seconds.
The LDP recovery time refers to the maximum time that the stale state label is kept by the LSR after a TCP
reconnection.
Modifying the LDP recovery time will cause all LDP sessions and all LSPs based on the sessions to be
removed and then reestablished.
Syntax
graceful-restart timer recovery timer
undo graceful-restart timer recovery

HP 5800 Series Specifications

General

MAC Address Table Size	32, 000 entries
Uplink Ports	2 or 4 SFP+ 10GbE ports
Routing Protocol	BGP, IS-IS
Input Voltage	100-240 VAC
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 95% (noncondensing)
PoE	Optional
Power Supply	Redundant power supply (optional)