HP 5800 Series

265
Default level
2: System level
Parameters
policy-name: Specifies the name of the tunneling policy, which is a case-insensitive string of 1 to 19
characters.
Examples
# Specify tunneling policy tp100 for PW class template pw100.
<Sysname> system-view
[Sysname] pw-class pw100
[Sysname-pw-pw100] pw-tunnel-policy tp100
reset bgp l2vpn
Description
Use the reset bgp l2vpn command to reset L2VPN BGP connections.
Syntax
reset bgp l2vpn { as-number | ip-address | all | external | internal }
View
User view
Default level
1: Monitor level
Parameters
as-number: Resets L2VPN BGP connections with the peers in the AS with this number. The AS number
must be ranging from 1 to 4,294,967,295.
ip-address: Resets the L2VPN BGP connection to the peer with this IP address.
all: Resets all L2VPN BGP connections.
external: Resets L2VPN EBGP sessions.
internal: Resets L2VPN IBGP sessions.
Examples
# Reset all L2VPN BGP connections.
<Sysname> reset bgp l2vpn all
route-distinguisher (MPLS L2VPN view)
Description
Use the route-distinguisher command to configure an RD for the VPN.
Different VPNs on a PE must have different RDs. A VPN can have the same or different RDs on different
PEs.
You cannot change an RD directly. You can only delete the VPN and then re-create the VPN using the
new RD.