HP 5800 Series - Delete Hop; Display Explicit-Path

116
delete hop
Description
Use the delete hop command to remove a specified node from the explicit path.
Syntax
delete hop ip-address
View
Explicit path view
Default level
2: System level
Parameters
ip-address: Specifies the IP address of a node along the explicit path.
Examples
# Remove the node identified by 10.0.0.1 from the explicit path path1.
<Sysname> system-view
[Sysname] explicit-path path1
[Sysname-explicit-path-path1] delete hop 10.0.0.1
display explicit-path
Description
Use the display explicit-path command to display information about an explicit path.
If you do not specify a path name, information about all explicit paths is displayed.
Syntax
display explicit-path [ pathname ] [ | { begin | exclude | include } regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
pathname: Specifies a path name, which is a string of 1 to 31 characters.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see the Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, which is a case-sensitive string of 1 to 256 characters.
Examples
# Display information about all explicit paths.