HP 5800 Series User Manual

55
Examples
# Display brief MPLS-related information about all interfaces with MPLS enabled.
<Sysname> display mpls interface
Interface Status TE Attr LSP Count CRLSP Count
Vlan1 Up En 0 0
Vlan2 Up En 0 0
# Display detailed MPLS related information about MPLS-enabled interface Vlan-interface 2.
<Sysname> display mpls interface vlan-interface 2 verbose
No : 1
Interface : Vlan2
Status : Down
TE Attribute : Disable
LSPCount : 0
CR-LSPCount : 0
FRR : Disabled
Table 21 Command output
Field Description
TE Attr/TE Attribute Whether TE is enabled on the interface.
LSP Count/LSPCount Number of LSPs on the interface.
CR-LSP Count/CR-LSPCount Number of CR-LSPs on the interface.
FRR
Whether FRR is enabled on the interface. If FRR is
enabled, the output will also include the bound
tunnels.
NOTE:
For information about FRR, see the
MPLS Configuration Guide .
display mpls label
Description
Use the display mpls label command to display usage information about specified labels or all labels.
Syntax
display mpls label { label-value1 [ to label-value2 ] | all } [ | { begin | exclude | include } regular-
expression ]
View
Any view
Default level
1: Monitor level
Parameters
label-value1: Specifies a label, or, when used with the label-value2 parameter, the start label of a range
of labels. The value of this parameter ranges from 16 to 204,799.

HP 5800 Series Specifications

General

MAC Address Table Size	32, 000 entries
Uplink Ports	2 or 4 SFP+ 10GbE ports
Routing Protocol	BGP, IS-IS
Input Voltage	100-240 VAC
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 95% (noncondensing)
PoE	Optional
Power Supply	Redundant power supply (optional)