HP 5800 Series User Manual

148
Field Description
ExcludeAllAff Link properties that are excluded
IncludeAllAff All link affinity properties that must be included
Created Time Time when the tunnel was created
display mpls te tunnel path
Description
Use the display mpls te tunnel path command to display the path or paths that the specified or all MPLS
TE tunnels traverse on this node.
Syntax
display mpls te tunnel path [ lsp-id lsr-id lsp-id | tunnel-name tunnel-name ] [ | { begin | exclude |
include } regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
lsr-id: Specifies the ingress LSR ID, in dotted decimal notation.
lsp-id: Specifies the LSP ID, ranging from 1 to 65,535.
tunnel-name tunnel-name: Specifies the tunnel name, which is a string of 1 to 63 characters.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see the Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, which is a case-sensitive string of 1 to 256 characters.
Examples
# Display the paths that all MPLS TE tunnels traverse.
<Sysname> display mpls te tunnel path
Tunnel Interface Name : Tunnel0
Lsp ID : 1.1.1.9:10
Hop information:
Hop 0: 192.1.1.1;
Hop 1: 12.1.1.2;
Hop 2: 10.202.2.2.

HP 5800 Series Specifications

General

MAC Address Table Size	32, 000 entries
Uplink Ports	2 or 4 SFP+ 10GbE ports
Routing Protocol	BGP, IS-IS
Input Voltage	100-240 VAC
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 95% (noncondensing)
PoE	Optional
Power Supply	Redundant power supply (optional)