HP 5800 Series User Manual

157
Parameters
None
Examples
# Enable IGP shortcut when the IGP protocol is OSPF.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] enable traffic-adjustment
enable traffic-adjustment advertise
Description
Use the enable traffic-adjustment advertise command to enable forwarding adjacency.
Use the undo enable traffic-adjustment advertise command to disable forwarding adjacency.
By default, forwarding adjacency is disabled.
Forwarding adjacency allows OSPF to include static LSP tunnels in SPF calculation, but not advertise them
to OSPF neighbors.
Syntax
enable traffic-adjustment advertise
undo enable traffic-adjustment advertise
View
OSPF view
Default level
2: System level
Parameters
None
Examples
# Enable forwarding adjacency when the IGP protocol is OSPF.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] enable traffic-adjustment advertise
explicit-path
Description
Use the explicit-path command to create an explicit path and enter its view.
Use the undo explicit-path command to remove an explicit path.
Syntax
explicit-path pathname [ disable | enable ]
undo explicit-path pathname

HP 5800 Series Specifications

General

MAC Address Table Size	32, 000 entries
Uplink Ports	2 or 4 SFP+ 10GbE ports
Routing Protocol	BGP, IS-IS
Input Voltage	100-240 VAC
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 95% (noncondensing)
PoE	Optional
Power Supply	Redundant power supply (optional)