HP 5800 Series User Manual

175
Default level
2: System level
Parameters
None
Examples
# Enable CSPF.
<Sysname> system-view
[Sysname] mpls
[Sysname-mpls] mpls te cspf
mpls te cspf timer failed-link
Description
Use the mpls te cspf timer failed-link command to configure the failed link timer.
Use the undo mpls te cspf timer failed-link command to restore the default.
Related commands: mpls te cspf.
Syntax
mpls te cspf timer failed-link timer-interval
undo mpls te cspf timer failed-link
View
MPLS view
Default level
2: System level
Parameters
timer-interval: Specifies the failed link timer setting, ranging from 0 to 300 seconds. The default is 10
seconds.
Examples
# Set the failed link timer to 50 seconds.
<Sysname> system-view
[Sysname] mpls
[Sysname-mpls] mpls te cspf timer failed-link 50
mpls te failure-action teardown
Description
Use the mpls te failure-action teardown command to enable the capability of tearing down a failed RSVP
TE tunnel and then re-establishing it.
Use the undo mpls te failure-action teardown command to disable the capability.
By default, this capability is disabled.

HP 5800 Series Specifications

General

MAC Address Table Size	32, 000 entries
Uplink Ports	2 or 4 SFP+ 10GbE ports
Routing Protocol	BGP, IS-IS
Input Voltage	100-240 VAC
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 95% (noncondensing)
PoE	Optional
Power Supply	Redundant power supply (optional)