355
Field Description
BGP version Version of BGP that the peer runs.
remote router ID Router ID of the peer.
BGP current state Current state of the BGP session.
Up for Duration since the peer is established.
BGP current event Current event of the BGP session.
BGP last state
State that the BGP session was in before transitioning to the current
state.
Port Local and remote ports of the BGP session.
Configured
Settings of the local timers, including the active hold interval and
keepalive interval.
Received Received active hold interval.
Negotiated Negotiated active hold interval.
Peer optional capabilities Optional capabilities of the peer.
Peer support bgp multi-protocol
extended
The peer supports multiprotocol extension.
Peer support bgp route refresh
capability
The peer supports route refreshing.
Address family IPv6 Unicast IPv6 unicast family capability.
Received
Total number of received messages and the number of received update
messages.
Sent
Total number of sent messages and the number of sent update
messages.
Maximum allowed prefix number Maximum number of routes that the VPN instance supports.
Threshold
Threshold for warning. When the percentage of the number of the
received route prefixes to the maximum number of routes supported
reaches this value, the device generates a prompt.
Minimum time between
advertisement runs
Minimum interval between route advertisements.
Optional capabilities Local optional capabilities.
Route refresh capability Whether route refreshing is enabled.
Peer Preferred Value Preference value specified for routes from the peer.
display bgp vpnv6 vpn-instance routing-table
Description
Use the display bgp vpnv6 vpn-instance routing-table command to display the BGP VPNv6 routing
information of the specified VPN.