HP 5800 Series User Manual

263
View
Any view
Default level
0: Visit level
Parameters
-a source-ip: Specifies the source IP address of the Echo Request messages to be sent.
-c count: Specifies the number of request messages to be sent. The count parameter ranges from 1 to
4,294,967,295 and defaults to 5.
-exp exp-value: Specifies the EXP value for the Echo Request messages. The exp-value parameter ranges
from 0 to 7 and defaults to 0.
-h ttl-value: Specifies the TTL value for the Echo Request messages. The ttl-value parameter ranges from 1
to 255 and defaults to 255.
-m wait-time: Specifies the interval for sending Echo Request messages. The wait-time parameter ranges
from 1 to 10,000 and defaults to 200, in milliseconds.
-r reply-mode: Specifies the reply mode of a receiver in response to an Echo Request message. The reply-
mode parameter can be 1 or 2 where 1 means “Do not respond” and 2 means “Respond using a UDP
packet.” The default is 2.
-s packet-size: Specifies the payload length of the Echo Request messages. The packet-size parameter
ranges from 65 to 8100 and defaults to 100, in bytes.
-t time-out: Specifies the timeout interval for waiting for the response to an echo request message. The
time-out parameter ranges from 0 to 65,535 and defaults to 2000, in milliseconds.
-v: Displays detailed response information.
pw ip-address: Specifies the IP address of the peer PE.
pw-id pw-id: Specifies the ID of the PW to the peer PE. The pw-id parameter ranges from 1 to
4,294,967,295.
Examples
# Check the validity and reachability of the VC that is with PW ID 301 and connected to peer PE 3.3.3.9.
<Sysname> ping lsp pw 3.3.3.9 pw-id 301
LSP Ping FEC: FEC 128 PSEUDOWIRE (NEW) 3.3.3.9 301 : 100 data bytes, press CTRL_C to
break
Reply from 100.1.2.1: bytes=100 Sequence=0 time = 31 ms
Reply from 100.1.2.1: bytes=100 Sequence=1 time = 62 ms
Reply from 100.1.2.1: bytes=100 Sequence=2 time = 62 ms
Reply from 100.1.2.1: bytes=100 Sequence=3 time = 62 ms
Reply from 100.1.2.1: bytes=100 Sequence=4 time = 62 ms
--- FEC: FEC 128 PSEUDOWIRE (NEW) 3.3.3.9 301 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 31/55/62 ms

HP 5800 Series Specifications

General

MAC Address Table Size	32, 000 entries
Uplink Ports	2 or 4 SFP+ 10GbE ports
Routing Protocol	BGP, IS-IS
Input Voltage	100-240 VAC
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 95% (noncondensing)
PoE	Optional
Power Supply	Redundant power supply (optional)