153
Parameters
process-id: Specifies the OSPF process ID, ranging from 1 to 65,535. If you specify a process, only the TE
LSAs of this process are displayed. If you do not specify a process, the TE LSAs of all processes are
displayed.
area area-id: Displays the TE LSAs of a specified OSPF area. The area-id parameter takes an integer
ranging from 0 to 4,294,967,295 or the form of IPv4 address.
self-originated: Displays self originated TE LSAs.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see the Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, which is a case-sensitive string of 1 to 256 characters.
Examples
# Display all TE LSAs in the LSDB.
<Sysname> display ospf mpls-te
OSPF Process 100 with Router ID 10.0.0.1
Area ID:
Traffic Engineering LSA’s of the database
------------------------------------------------
LSA []
------------------------------------------------
LSA Type : Opq-Area
Opaque Type : 1
Opaque ID :
Advertising Router ID : xxx.xxx.xxx.xxx
LSA Age :
Length :
LSA Options :
LS Seq Number :
CheckSum :
Link Type :Point to Point / Point to Multi Point /MultiAccess
Link ID :
Local Interface Address : xxx.xxx.xxx.xxx
Remote Interface Address : xxx.xxx.xxx.xxx
TE Metric :
Admin Group :
Table 71 Command output
Field Description
Area ID TE enabled OSPF area ID.
LSA Type LSA type which must be Opd-Area, carried in the Opaque LSA header
To Next Page
Loading...
Need help?
General
