HP 5800 Series User Manual

379
Parameters
vpn-target&<1-8>: Adds VPN target extended community attributes to the import VPN target extended
community attribute list (Import Target) or export VPN target extended community attribute list (Export
Target). &<1-8> means that you can add up to eight VPN targets.
A VPN target attribute can be a string of 3 to 21 characters in one the following formats:
• 16-bit AS number:32-bit user-defined number. For example, 101:3.
• 32-bit IP address:16-bit user-defined number. For example, 192.168.122.15:1.
• 32-bit AS number:16-bit user-defined number, where the AS number must not be less than 65,536.
For example, 65536:1.
both: Uses the specified VPN targets as both import targets and export targets. The both keyword is also
used when you do not specify any of both, export-extcommunity, and import-extcommunity.
export-extcommunity: Uses the specified VPN targets as export targets.
import-extcommunity: Uses the specified VPN targets as import targets.
all: Removes all VPN targets.
Examples
# Configure VPN targets for VPN instance vpn1.
<Sysname> system-view
[Sysname] ip vpn-instance vpn1
[Sysname-vpn-instance-vpn1] vpn-target 3:3 export-extcommunity
[Sysname-vpn-instance-vpn1] vpn-target 4:4 import-extcommunity
[Sysname-vpn-instance-vpn1] vpn-target 5:5 both
# Configure VPN targets for the IPv6 VPN of VPN instance vpn3.
<Sysname> system-view
[Sysname] ip vpn-instance vpn3
[Sysname-vpn-instance-vpn3] ipv6-family
[Sysname-vpn-ipv6-vpn3] vpn-target 3:3 export-extcommunity
[Sysname-vpn-ipv6-vpn3] vpn-target 4:4 import-extcommunity
[Sysname-vpn-ipv6-vpn3] vpn-target 5:5 both

HP 5800 Series Specifications

General

MAC Address Table Size	32, 000 entries
Uplink Ports	2 or 4 SFP+ 10GbE ports
Routing Protocol	BGP, IS-IS
Input Voltage	100-240 VAC
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 95% (noncondensing)
PoE	Optional
Power Supply	Redundant power supply (optional)