HP 5800 Series User Manual

7
Port: Local - 179 Remote - 1025
Configured: Active Hold Time: 180 sec Keepalive Time:60 sec
Received : Active Hold Time: 180 sec
Negotiated: Active Hold Time: 180 sec
Peer optional capabilities:
Peer support bgp multi-protocol extended
Peer support bgp route refresh capability
Address family IPv4 Unicast: advertised and received
Received: Total 25 messages, Update messages 1
Sent: Total 30 messages, Update messages 4
Maximum allowed prefix number: 150000
Threshold: 75%
Minimum time between advertisement runs is 30 seconds
Optional capabilities:
ORF advertise capability based on Prefix(type 64):
Local: both
Negotiated: send
Peer Preferred Value: 99
BFD: Enabled
Routing policy configured:
No routing policy is configured
Table 5 Command output
Field Description
Peer IP address of the peer.
Local IP address of the local router.
Type BGP type.
BGP version Version of BGP that the peer runs.
remote router ID Router ID of the remote router.
BGP current state Current status of the BGP session.
Up for Duration since the peer is established.
BGP current event Current event of the BGP session.
BGP last state
State that the BGP session was in before transitioning to the
current status.
Port Local and remote ports of the BGP session.
Configured
Settings of the local timers, including the active hold interval
and keepalive interval.
Received Received active hold interval.
Negotiated Negotiated active hold interval and keepalive time.
Peer optional capabilities Optional capabilities of the peer.
Peer support bgp multi-protocol extended The peer supports multiprotocol extension.

HP 5800 Series Specifications

General

MAC Address Table Size	32, 000 entries
Uplink Ports	2 or 4 SFP+ 10GbE ports
Routing Protocol	BGP, IS-IS
Input Voltage	100-240 VAC
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 95% (noncondensing)
PoE	Optional
Power Supply	Redundant power supply (optional)