74
Default level
1: Monitor level
Parameters
destination-address mask-length: Displays the BFD information of the LSPs for the specified FEC.
destination-address is the destination IP address of the FEC. mask-length is the mask length of the FEC
destination address, ranging from 0 to 32.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see the Fundamentals Configuration Guide.
• begin: Displays the first line that matches the specified regular expression and all lines that follow.
• exclude: Displays all lines that do not match the specified regular expression.
• include: Displays all lines that match the specified regular expression.
• regular-expression: Specifies a regular expression, which is a case-sensitive string of 1 to 256
characters.
Examples
# Display the BFD check information of the LSPs for destination 1.1.1.9/32.
<Sysname> display mpls lsp bfd ipv4 1.1.1.9 32
MPLS BFD Session(s) Information
-----------------------------------------------------------------------------
FEC : 1.1.1.9/32 Type : LSP
Local Discr : 1 Remote Discr : 1
Tunnel ID : 0xd2007 NextHop : 11.1.1.2
Session State : Up Source IP : 1.1.1.1
Session Role : Active
FEC : 1.1.1.9/32 Type : LSP
Local Discr : 2 Remote Discr : 2
Tunnel ID : 0xd2008 NextHop : 12.1.1.2
Session State : Up Source IP : 1.1.1.1
Session Role : Active
Total Session Num: 2
Table 33 Command output
Field Description
Type
Type of the tunnel detected by BFD, which can be LSP or
TE Tunnel
Local Discr Local discriminator value of the BFD session
Remote Discr Remote discriminator value of the BFD session
Session State
BFD session state, including:
• Init—The BFD session is in the initialization state
• Up—The BFD session is up
• Down—The BFD session is down
To Next Page
Loading...
Need help?
General
