HP 8360 B Series User Manual

SCPI COMMAND SUMMARY
mapping of the frequency parameters on input to and output from
the swept signal generator. Changing this does not affect the
output frequency of the swept signal generator. Only the displayed
parameters and query responses are changed. The equation implied
by this is :
Entered/displayed frequency = (Hardware Freq * Multiplier ) + Offset
After *RST, the value is 0.
l FREQuency:OFFSet:STATe ONlOFFlllO
l FREQuency:OFFSet:STATe?
Queries and turns the frequency offset off and on.
After *RST, the setting is OFF.
l FREQuency:SPAN <num>[freq
suffix]lMAXimumlMINimumlUPlDOWN
l FREQuency:SPAN? [MAXimumlMINimum~
Sets and queries the frequency span. See FREQ : CENTER for more
information.
l FREQuency:STARt <num>[freq suffix]
lMAXimumlMINimumlUPlDOWN
l FREQuency:STARt? CMAXimumlMINimuml
Sets and queries the START Frequency. See FREQ : CENTER for more
information. *RST setting is MIN.
l FREQuency:STEP:AUTO ONlOFFlllO
l FREQuency:STEP:AUTO?
Sets and queries the function switch that controls the calculation of
the frequency step size (FREQ:STEP:INCR). If the response is
AUTO ON, then the swept signal generator selects a step size that is
coupled to the frequency span. The *RST setting is ON.
l FREQuency:STEP[:INCRement] <num>[freq
suffix]lMAXimumlMINimum
l FREQuency:STEP[:INCRement]?
Sets and queries the frequency step size to use for any node in the
frequency subsystem that allows UP and DOWN as parameters. Setting
this value explicitly causes a FREQ:STEP:AUTO OFF command.
The *RST setting is automatically calculated from span.
l FREQuency:STOP <num>Cfreq
suffixllMAXimumlMINimumlUPlDOWN
a FREQuency:STOP? [MAXimumlMINimuml
Sets and queries the stop Frequency. See FREQ : CENTER for more
information.
*RST setting is MAX.
Operating and Programming Reference S-37

HP 8360 B Series Specifications

General

Brand	HP
Model	8360 B Series
Category	Portable Generator
Language	English