HP 8360 B Series User Manual

SCPI COMMAND SUMMARY
Sets and queries the CW frequency. This does not change the
swept/CW mode switch. *RST value is (MAX + MIN)/2 .
See FREQ : CENTER for more information.
l FREQuency[:CW]:AUTO ONlOFFlllO
l FREQuency[:FIXed]:AUTO ONlOFFlllO
l FREQuency[:CWl:AUTO?
l FREQuency[:FIXed]:AUTO?
Sets and queries the CW/ center frequency coupling switch. This
switch keeps the two functions coupled together when ON. Changing
one ofthem, changes both. *RST setting is OFF. See FREQ:CENTER
for more information.
l FREQuency:MANual <num>[freq
suffix]lMAXimumlMINimumlUPlDOWN
l FREQuency:MANual? [MAXimumlMINimuml
Sets and queries the manual frequency. This controls the output
frequency in swept manual mode. The limits are START and STOP.
*RST valueis the same as FREQ:CENTER. See FREQ:CENTERfor more
information.
l FREQuency:MODE FIXedlCWlSWEeplLIST
l FREQuency:MODE?
Sets and queries the switch that selects either swept, CW or list
operation. *RST value is CW.
l FREQuency:MULTiplier <num>lMAXimumlMINimum
l FREQuency:MULTiplier? [MAXimumlMINimuml
Sets and queries the frequency multiplier. The numeric value is
rounded to the nearest integer. This function changes mapping of
frequency parameters on input to and output from the swept signal
generator. Changing this does not affect the output frequency of the
swept signal generator. Only the displayed parameters and query
responses are changed.
The equation implied by this is :
Entered/displayed frequency = (Hardware Freq * Multiplier ) + Offset
After *RST, the value is 1.
l FREQuency:MULTiplier:STATe ONlOFFlllO
l FREQuency:MULTiplier:STATe?
Queries and turns the frequency multiplier off and on.
After *RST, the setting is OFF.
l FREQuency:OFFSet Cnum>lMAXimumlMINimum
l FREQuency:OFFSet? [MAXimumlMINimuml
Sets and queries the frequency offset. This function changes the
S-36 Operating and Programming Reference

HP 8360 B Series Specifications

General

Brand	HP
Model	8360 B Series
Category	Portable Generator
Language	English