HP 8360 B Series User Manual

SCPI COMMAND SUMMARY
POWer:ALC:STATe
POWer:SEARch
Power Switch Action
ON
ON
ALC is momentarily closed to
level at the requested power,
and then the modulator is set to
the same voltage in open loop
mode. This repeats automatically
any time that the power level or
frequency is changed.
ON OFF Normal mode.
I
ON
ONCE Immediately performs a power
search. This leaves POWer:SEARch
in the ON position.
I
OFF
not applicable Modulator setting is
explicitly set by user.
l POWer : SLOPe <num> [DB/f req
suffix]lMAXimumlMINimumlUP~DOWN
l POWer : SLOPe? [MAXimum I MINimum]
Sets and queries the RF slope setting (dB per Hz).
FREQ:MODE Affect on Slope
CW or LIST Rotates around 0 Hz.
SWEep or
Rotates around the start frequency.
STEP
The *RST value is 0.
l POWer:SLOPe:STATe ONlOFFlllO
l POWer:SLOPe:STATe?
Sets and queries the power slope state. *RST value is 0.
l POWer:SPAN <num>[DB] ~MAXimumlMINimumlUPlDOWN
l POWer : SPAN? [MAXimum I MINimum]
The coupling equations for power sweep are exactly analogous to
those for frequency sweep. Power sweep is allowed to be negative,
unlike frequency sweeps. *RST value is 0.
l POWer:STARt <num>[lvlsuffix] lMAXimumlMINimumlUPlDOWN
l POWer:STARt? [MAXimumlMINimum]
Default units and units for query response are determined by the
command UNIT:POWer. The coupling equations for power sweep
are exactly analogous to those for frequency sweep. Power sweep is
allowed to be negative, unlike frequency sweeps.
*RST value is 0 dBm.
l POWer:STATe ONlOFFlllO
l POWer : STATe?
Sets and queries the output power on/off state. *RST value is OFF.
S-44 Operating and Programming Reference

HP 8360 B Series Specifications

General

Brand	HP
Model	8360 B Series
Category	Portable Generator
Language	English