l
STATUS:PRESet
This command presets the following enable and transition registers:
MSIB,
OPERation,
QUEStionable,
and
SRECeiver.
ENABle
Is set to all
0s.
NTRansition
Is set to all
0s.
PTRansition
All bits used are set to
1s.
Unused bits remain
OS.
l
STATus:QUEStionable:CONDition?
Queries the Data Questionable Condition Register.
l
STATus:QUEStionable:ENABle
<mm>
l
STATus:QUEStionable:ENABle?
Sets and queries the Data Questionable SRQ Enable register.
The
STATus:PRESet
value is 0.
l
STATus:QUEStionable[:EVENt]?
Queries the Data Questionable Event Register. This is a destructive
read.
l
STATus:QUEStionable:NTRansition
<rum>
l
STATus:QUEStionable:NTRansition?
Sets and queries the Negative
TRansition
Filter for the Data
Questionable Status Register. The
STAT
US
:PRESet
value is 0.
l
STATus:QUEStionable:PTRansition
Cnum>
l
STATus:QUEStionable:PTRansition?
Sets and queries the Positive
TRansition
Filter for the Data
Questionable Status Register. After
STAT
US
:
PRESet,
all used bits are
set to
1s.
S-48 Operating and Programming Reference
To Next Page
Loading...
Need help?
General
