HP 8360 B Series User Manual

SCPI COMMAND SUMMARY
l PULM:SLEW:AUTO ONlOFFlllO
l PULM:SLEW:AUTO?
Sets and queries the automatic setting of rise time for the pulse
modulation system. The *RST setting is ON.
l PULM:SOURce INTernallEXTernallSCALar
l PULM:SOURce?
Sets and queries the source for the pulse modulation control signal.
*RST value is INTernal.
l PULM:STATe ONlOFFlllO
l PULM:STATe?
Sets and queries the state of pulse modulation. The *RST value is 0.
a ROSCillator:SOURce?
l ROSCillator:SOURce INTernallEXTernallNONE
Sets and queries the reference oscillator selection switch. The
command to set the switch will cause ROSC:SOUR:AUTO OFF to
be done also. The ‘RST value is automatically determined.
l ROSCillator:SOURce:AUTO ONlOFFlllO
l ROSCillator:SOURce:AUTO?
Sets and queries the automatic reference selection switch.
The *RST value is 1.
l STATus:OPERation:CONDition?
Queries the Standard Operation Condition register.
l STATus:OPERation:ENABle <num>
l STATus:OPERation:ENABle?
Sets and queries the Standard Operation Enable register.
The STATus:PRESet value is 0.
l STATus:OPERation[:EVENt]?
Queries the Standard Operation Event Register. This is a destructive
read.
l STATus:OPERation:NTRansition Q-mm>
l STATus:OPERation:NTRansition?
Sets and queries the Standard Operation Negative Transition Filter.
The STATus:PRESet value is 0.
l STATus:OPERation:PTRansition <mm>
l STATus:OPERation:PTRansition.?
Sets and queries the Standard Operation Positive Transition Filter.
After STATus:PRESet, all used bits are set to 1s.
Operating and Programming Reference S-47

HP 8360 B Series Specifications

General

Brand	HP
Model	8360 B Series
Category	Portable Generator
Language	English