HP Aruba JL253A - Rate-Limit Unknown-Unicast in Kbps

mcast Set a rate limit for multicast traffic.
queues Set a rate limit for each traffic queue.
unknown-unicast Set a rate limit for unicast flood traffic.
switch(eth-2)# rate-limit unknown-unicast
in Set a rate limit for incoming unicast flood traffic.
switch(eth-2)# rate-limit unknown-unicast in
kbps
percent
switch(eth-2)# rate-limit unknown-unicast in percent 10
switch(eth-2)# show rate-limit
bcast Show broadcast traffic rate limits.
icmp Show ICMP traffic rate limits.
mcast Show multicast traffic rate limits.
queues Show limits for outgoing queue traffic.
unknown-unicast Show unicast flood traffic rate limits.
switch(eth-2)# show rate-limit unknown-unicast
[ethernet] PORT-LIST The ports to show information for.
switch(eth-2)# show rate-limit unknown-unicast 2
Unknown-Unicast Traffic Rate Limit Maximum %
Port | Inbound Limit Mode
----- + ------------- ---------
2 | 10 %
rate-limit unknown-unicast in kbps
Syntax
interface port-list rate-limit unknown-unicast in kbps rate
Description
Sets a rate limit for unicast flood traffic.
Command context
interface
Parameters
in
Sets a rate limit for incoming unicast flood traffic.
percent
Specifies the rate limit as a percentage of the total available bandwidth.
kbps
Specifies the rate limit in Kb/s.
Examples
switch(config)# int 1
switch(eth-1)# rate-limit
all Set a rate limit for all traffic.
bcast Set a rate limit for broadcast traffic.
icmp Set a rate limit for ICMP traffic.
mcast Set a rate limit for multicast traffic.
queues Set a rate limit for each traffic queue.
unknown-unicast Set a rate limit for unicast flood traffic.
Chapter 6 Port Traffic Controls 171