(UDP port 9512 is used.)
Syntax:
[no] logging facility <facility-name>
The logging facility specifies the destination subsystem used in a configured syslog server. (All configured syslog
servers must use the same subsystem.) Hewlett Packard Enterprise recommends the default (user) subsystem
unless your application specifically requires another subsystem. Options include:
user
(default) Random user-level messages
kern
Kernel messages
mail
Mail system
daemon
System daemons
auth
Security/authorization messages
syslog
Messages generated internally by syslog
lpr
Line-printer subsystem
news
Netnews subsystem
uucp
uucp subsystem
cron
cron/at subsystem
sys9
cron/at subsystem
sys10 - sys14
Reserved for system use
local10 - local17
Reserved for system use
Use the no form of the command to remove the configured facility and reconfigure the default (user) value.
Adding a description for a Syslog server
You can associate a user-friendly description with each of the IP addresses (IPv4 only) configured for syslog
using the CLI or SNMP.
NOTE:
The Hewlett Packard Enterprise MIB hpicfSyslog.mib allows the configuration and monitoring of
syslog for SNMP (RFC 3164 supported).
CAUTION:
Entering the no logging command removes ALL the syslog server addresses without a verification
prompt.
The CLI command is:
Chapter 13 Troubleshooting 523
To Next Page
Loading...
