Event Log messages
Please see the Event Log Message Reference Guide for information about Event Log messages.
Locating a switch (Locator LED)
To locate where a particular switch is physically installed, use the chassislocate command to activate the blue
Locator LED on the switch's front panel.
Syntax:
chassislocate [blink | on | off]
Locates a switch by using the blue Locate LED on the front panel.
blink <1-1440>
Blinks the chassis Locate LED for a specified number of minutes (Default: 30
minutes).
on <1-1440>
Turns the chassis Locate LED on for a specified number of minutes (Default: 30
minutes).
off
Turns the chassis Locate LED off.
Locating a switch with the chassislocate command
switch(config)# chassislocate
blink <1-1440> Blink the chassis locate led (default 30 minutes).
off Turn the chassis locate led off.
on <1-1440> Turn the chassis locate led on (default 30 minutes).
switch(config)# chassislocate
For redundant management systems, if the active management module failsover, the Locator LED does not
remain lit.
550 Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08
To Next Page
Loading...
