Product # Description Support
1
J9150A 10GbE SFP+ SR
Transceiver
D
J9151A 10GbE SFP+ LR
Transceiver
D
J9152A 10GbE SFP+ LRM
Transceiver
D
J9153A 10GbE SFP+ ER
Transceiver
D
J9144A 10GbE X2-SC LRM
Transceiver
D
J8438A 10Gbe X2-SC ER
Transceiver
D
1
Support indicators:
• V - Validated to respond to DOM requests
• N - No support of DOM
• D - Documented by the component suppliers as supporting DOM
• NA - Not applicable to the transceiver (copper transceiver)
NOTE: Not all transceivers support Digital Optical Monitoring. If DOM appears in the Diagnostic
Support field of the show interfaces transceiver detail command, or the
hpicfTransceiverMIB hpicfXcvrDiagnostics MIB object, DOM is supported for that transceiver.
Using the Event Log for troubleshooting switch problems
The Event Log records operating events in single- or double-line entries and serves as a tool to isolate and
troubleshoot problems.
Once the log has received 2000 entries, it discards the oldest message each time a new message is received.
The Event Log window contains 14 log entry lines. You can scroll through it to view any part of the log.
Once the log has received 2000 entries, it discards the oldest message each time a new message is received.
The Event Log window contains 14 log-entry lines. You can scroll through it to view any part of the log.
NOTE:
The Event Log is erased if power to the switch is interruptedor if you enter the boot system
command. The contents of the Event Log are not erased if you:
• Reboot the switch by choosing the Reboot Switch option from the menu interface.
• Enter the reload command from the CLI.
488 Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08
To Next Page
Loading...
