HP Aruba JL253A - Displaying Information about the Mac-Count-Notify Option

Configuring mac-count notify traps on ports 5–7
switch (config)# mac-count-notify traps 5-7 50
Displaying information about the mac-count-notify option
Use the show mac-count-notify traps [<port-list>] command to display information about the configured value for
sending a trap, the current count, and if a trap has been sent.
Information displayed for the show mac-count-notify traps command
switch(config)# show mac-count-notify traps
Mac-count-notify Enabled: Yes
Port Count for Count Trap Sent
sending Trap
------ --------------- ------- ------------
1
2
3
4
5 50 0 No
6 50 2 No
7 50 0 No
8
9
...
The interface context can be used to configure the value for sending a trap.
Configuring mac-count-notify traps from the interface context
switch(config)# interface 5
Switch (eth-5)# mac-count-notify traps 35
The show snmp-server traps command displays whether the MAC Address Count feature is enabled or
disabled.
Information about SNMP traps, including MAC address count being Enabled/Disabled
switch(config)# show snmp-server traps
Trap Receivers
Link-Change Traps Enabled on Ports [All] : All
Traps Category Current Status
____________________________ __________________
SNMP Authentication : Extended
Password change : Enabled
Login failures : Enabled
Port-Security : Enabled
Authorization Server Contact : Enabled
DHCP-Snooping : Enabled
Dynamic ARP Protection : Enabled
Dynamic IP Lockdown : Enabled
212 Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08