Debug/syslog configuration commands
Event notification logging — Automatically sends switch-level
event messages to the switch's
Event Log. Debug and syslog do
not affect this operation, but add the
capability of directing Event Log
messaging to an external device.
logging command
<syslog-ip-addr>
Enables syslog messaging to be
sent to the specified IP address.
IPv4 and IPv6 are supported.
facility
(Optional) The logging
facility command specifies the
destination (facility) subsystem used
on a syslog server for debug
reports.
priority-desc
A text string associated with the
values of facility, severity, and
system-module.
neighbor-adjacency
[detail]
Enables or disables OSPFv3 (IPv6)
adjacency logging. Must be
executed in OSPFv3 context. The
detail option displays all the
adjacency state transitions and
adjacency-related errors.
severity
Sends Event Log messages of
equal or greater severity than the
specified value to configured debug
destinations. (The default setting is
to send Event Log messages from
all severity levels.)
system-module
Sends Event Log messages from
the specified system module to
configured debug destinations. The
severity filter is also applied to the
system-module messages you
select.
The default setting is to send Event
Log messages from all system
modules. To restore the default
setting, enter the no logging
system-module <system-
module> or logging system-
module all-pass commands.
Table Continued
510 Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08
To Next Page
Loading...
