HP Aruba JL253A - Show Snmp-Server Traps; Show Distributed-Trunking Consistency-Parameters

show snmp-server traps
Syntax
show snmp-server traps <COMMUNITY-STR>
Description
Shows traps controlled. Shows all information on SNMP communities, trap receivers and SNMP response or trap
source-ip policy configured on the switch.
Parameters and options
traps
Show all configured traps.
<COMMUNITY-STR>
Displays information for the specified community only.
Show snmp-server traps
switch(config)# sh snmp-server traps
Trap Receivers
Link-Change Traps Enabled on Ports [All] : All
Traps Category Current Status
_____________________________ __________________
SNMP Authentication : Extended
Password change : Enabled
Login failures : Enabled
Port-Security : Enabled
Authorization Server Contact : Enabled
DHCP-Snooping : Enabled
DHCPv6-Snooping Out of Resource : Enabled
DHCPv6-Snooping Errant Replies : Enabled
Dynamic ARP Protection : Enabled
Dynamic IP Lockdown : Enabled
Dynamic IPv6 Lockdown Out of Resource : Enabled
Dynamic IPv6 Lockdown Violations : Enabled
Startup Config change : Disabled
Running Config Change : Disabled
MAC address table changes : Disabled
MAC Address Count : Disabled
Address Community Events Type Retry Timeout
Excluded MIBs
switch(config)#
Alignment change – right shifted
show distributed-trunking consistency-parameters
Syntax
show distributed-trunking consistency-parameters global feature
Description
Parameters and options
284 Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08