EasyManua.ls Logo

HP Aruba JL253A - ipv6 source-binding

HP Aruba JL253A
775 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ipv6 source-binding
Syntax
[no] ipv6 source-binding VLAN-ID IPV6-ADDR MAC-ADDR PORT-NUM IPV6-ADDR
Description
Add a DHCPv6 static binding entry into the binding table. Static binding entries will have infinite lifetime.
Parameters and options
VLAN-ID
The VLAN ID of the static binding entry.
Ipv6-ADDRESS
The Ipv6 address of the static binding entry.
MAC-ADDRESS
The MAC address of the static binding entry.
[ethernet] PORT-NUM
Port number of the static binding entry.
IPV6-ADDR
The Ipv6 link-local address of the static binding entry.
Validation rules
Validation Error/Warning/Prompt
Verify whether the vlan id is proper Invalid input:%s
Verify whether the mac-address is valid Invalid input:%s
Verify whether the ipv6 address is valid Invalid input:%s
Verify whether the port number is valid on the
device
Module not present for port or invalid port: <port-
num>
If any other addresses other than global unicast
address are entered
Invalid Ipv6 address
If the ipv6 address entered is not a unicast. Only Ipv6 unicast addresses are supported.
If a multicast ipv6 address is entered to configure a
binding.
Cannot configure a binding using a multicast IPV6
address.
If an invalid MAC address is being added into the
binding table.
Cannot add a %s MAC address to the table.
If an invalid port is used for configuring a static
binding
Port %s is invalid.
Table Continued
280 Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08

Table of Contents

Related product manuals