Copies fdr-log files to a user-specified file.
all
Copies all the log files from both management modules and all slots.
mm-active
Copies the active management module's log.
mm-standby
Copies the standby management module's log.
slot
Retrieves the crash log from the module in the identified slots.
USB
NOTE: The USB port is available only on the 2930M Switch Series.
usb-port
Syntax
usb-port
no usb-port
Description
Enables the USB port.
The no form of the command disables the USB port and any access to the device.
Command context
Config
show usb-port
Syntax
show usb-port
Description
Displays the status of the USB port. It can be enabled, disabled, or not present.
Command context
operator
Usage
One of the following messages indicates the presence or absence of a USB device:
• Not able to sense device in USB port
• USB device detected in port
• no USB device detected in port
Chapter 11 File Transfers 369
To Next Page
Loading...
