EasyManuals Logo

HP Aruba JL253A User Manual

HP Aruba JL253A
775 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #48 background imageLoading...
Page #48 background image
If include-credentials is configured, the SNTP authentication configuration is saved in the configuration file.
When the show config command is entered, all of the information that has been configured for SNTP
authentication displays, including the key-values.
Figure 2: Saved SNTP Authentication information when include-credentials is configured
SNTP unicast time polling with multiple SNTP servers
When running SNTP unicast time polling as the time synchronization method, the switch requests a time update
from the server you configured with either the Server Address parameter in the menu interface, or the primary
server in a list of up to three SNTP servers configured using the CLI. If the switch does not receive a response
from the primary server after three consecutive polling intervals, the switch tries the next server (if any) in the list.
If the switch tries all servers in the list without success, it sends an error message to the Event Log and
reschedules to try the address list again after the configured Poll Interval time has expired.
If there are already three SNTP server addresses configured on the switch, and you want to use the CLI to
replace one of the existing addresses with a new one, you must delete the unwanted address before you
configure the new one.
Displaying all SNTP server addresses configured on the switch (CLI)
The System Information screen in the menu interface displays only one SNTP server address, even if the switch
is configured for two or three servers. The CLI show management command displays all configured SNTP
servers on the switch.
How to list all SNTP servers configured on the switch
switch(config)# show management
Status and Counters - Management Address Information
Time Server Address : fe80::215:60ff:fe7a:adc0%vlan10
Priority SNTP Server Address Protocol Version
-------- ---------------------------------------------- ----------------
1 2001:db8::215:60ff:fe79:8980 7
2 10.255.5.24 3
3 fe80::123%vlan10 3
48 Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP Aruba JL253A and is the answer not in the manual?

HP Aruba JL253A Specifications

General IconGeneral
BrandHP
ModelAruba JL253A
CategorySwitch
LanguageEnglish

Related product manuals