HP Aruba JL253A - Configuration Restore with Force Option

Time Taken for Each Phase :
Calculating diff : 1 Seconds
Adding commands : 0 Seconds
Removing commands : 0 Seconds
switch(config)# show config files
Configuration files:
id | act pri sec | name
---+-------------+---------
1 | * * * | config
2 | |
3 | |
4 | |
5 | |
Configuration restore with force option
Prerequisites
Back up the configuration using traditional copy config or cfg-backup commands.
Procedure
1. Execute the show config files command. By default, the config file provides all the associations.
switch(config)# show config files
Configuration files:
id | act pri sec | name
---+-------------+-------
1 | * * * | config
2 | | file1
3 | | file2
4 | |
5 | |
2. Use cfg-restore flash file1 force command to see the configuration of file1.
switch(config)# cfg-restore flash file1 force
As the file1 configuration requires a reboot, a system reboot occurs. When the switch comes up, file1 is the
new active configuration.
switch(config)# sh config files
Configuration files:
id | act pri sec | name
---+-------------+---------
1 | * * | config
2 | * | file1
3 | | file2
4 | |
5 | |
NOTE: During a configuration restore with reboot, the association changes. To make the
configuration as a default configuration for subsequent system reboots, use startup-default
[<primary|secondary>] config FILENAME command.
568 Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08