HP Aruba JL253A - [No] Ip-Sla ID Monitor Threshold-Config; [No] Ip-Sla ID Monitor Packet-Loss; [No] Ip-Sla ID Monitor Test-Completion

[no] ip-sla <ID> monitor threshold-config
Syntax
[no] ip-sla <ID> monitor threshold-config [rtt | srcTodstTime | dstToSrcTime]
threshold-type [immediate | consecutive <COUNT>] threshold-value <UPPER-LIMIT>
<LOWER-LIMIT> action-type [trap | log | trap-log | none]
Description
Set upper and lower threshold parameters.
• threshold-type immediate: Take action immediately when the monitored parameters cross the threshold
upper limit (subsequent notifications for upper thresholds are not generated until the parameter values go
lower than the configured lower threshold value).
• threshold-type consecutive: Take action after threshold is hit consecutively for number of times.
• action-type: Describes action to be taken when the upper threshold is crossed.
• trap: Send snmp-trap when configured threshold is hit.
• log: Only log the event when configured threshold is hit.
• trap-log: Send snmp-trap and log the event when configured threshold is hit.
• none: Take no action.
NOTE: The command option threshold-config can be individually set for rtt, srcTodstTime, and
dstToSrcTime.
[no] ip-sla <ID> monitor packet-loss
Syntax
[no] ip-sla <ID> monitor packet-loss threshold-type [immediate | consecutive
<COUNT>] action-type [trap | log | trap-log | none]
Description
Configure threshold-action values when packet loss happens.
• threshold-type immediate: Take action immediately when the monitored parameters cross the threshold
upper limit (subsequent notifications for upper thresholds are not generated until the parameter values go
lower than the configured lower threshold value).
• threshold-type consecutive: Take action after threshold is hit consecutively for number of times.
• action-type: Describes action to be taken when the upper threshold is crossed.
• trap: Send snmp-trap when configured threshold is hit.
• log: Only log the event when configured threshold is hit.
• trap-log: Send snmp-trap and log the event when configured threshold is hit.
• none: Take no action.
[no] ip-sla <ID> monitor test-completion
Syntax
[no] ip-sla <ID> monitor test-completion action-type [trap | log | trap-log | none]
Chapter 17 IP Service Level Agreement 591