HP Aruba JL253A - Fault-Finder Multicast-Storm Action

fault-finder multicast-storm action
Syntax
fault-finder multicast-storm [action {warn | warn-and-disable}] [sensitivity {low | medium |high}]
no fault-finder multicast-storm [action {warn | warn-and-disable}] [sensitivity {low | medium |high}]
Description
Global command to configure multicast-storm. The no form of the command disables multicast-storm
configuration on the port. The default sensitivity is medium and the default action is warn.
Parameters
warn
Log an event only
warn-and-disable
Log an event and disable the port
low
Low sensitivity
medium
Medium sensitivity
high
High sensitivity
Command context
config
Examples
switch(config)# fault-finder multicast-storm action warn
sensitivity Configure the fault sensitivity level.
switch(config)# fault-finder multicast-storm action warn sensitivity
low Low sensitivity.
medium Medium sensitivity.
high High sensitivity.
switch(config)# fault-finder multicast-storm action warn-and-disable
sensitivity Configure the fault sensitivity level.
switch(config)# fault-finder multicast-storm action warn-and-disable sensitivity
low Low sensitivity.
medium Medium sensitivity.
high High sensitivity.
switch(config)# fault-finder multicast-storm action warn-and-disable sensitivity high
Global show command for auto-100 duplex Smart Rate port:
switch(config)# show fault-finder
Fault Finder
Fault ID Sensitivity Action
------------------- ----------- ----------------
86 Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08