Viewing all SNTP authentication keys that have been configured on the switch (CLI)
Enter the show sntp authentication command, as shown in Show sntp authentication command output
on page 46.
Show sntp authentication command output
switch(config)# show sntp authentication
SNTP Authentication Information
SNTP Authentication : Enabled
Key-ID Auth Mode Trusted
------- ---------- --------
55 MD5 Yes
10 MD5 No
Viewing statistical information for each SNTP server (CLI)
To display the statistical information for each SNTP server, enter the show sntp statistics command.
The number of SNTP packets that have failed authentication is displayed for each SNTP server address, as
shown in SNTP authentication statistical information on page 46.
SNTP authentication statistical information
switch(config)# show sntp statistics
SNTP Statistics
Received Packets : 0
Sent Packets : 3
Dropped Packets : 0
SNTP Server Address Auth Failed Pkts
--------------------------------------- ----------------
10.10.10.1 0
fe80::200:24ff:fec8:4ca8 0
Saving configuration files and the include-credentials command
You can use the include-credentials command to store security information in the running-config file. This
allows you to upload the file to a TFTP server and then later download the file to the switches on which you want
to use the same settings. For more information about the include-credentials command, see "Configuring
Username and Password Security" in the access security guide for your switch.
The authentication key values are shown in the output of the show running-config and show config
commands only if the include-credentials command was executed.
When SNTP authentication is configured and include-credentials has not been executed, the SNTP
authentication configuration is not saved.
Configuration file with SNTP authentication information
switch(config) # show config
Startup configuration:
.
.
.
timesync sntp
46 Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08
To Next Page
Loading...
