Viewing a debug/syslog configuration
Use the show debug command to display the currently configured settings for:
• Debug message types and Event Log message filters (severity level and system module) sent to debug
destinations
• Debug destinations (syslog servers or CLI session) and syslog server facility to be used
Syntax:
show debug
Displays the currently configured debug logging destinations and message types selected for debugging
purposes. (If no syslog server address is configured with the logging <syslog-ip-addr> command, no
show debug command output is displayed.)
Output of the show debug command
switch(config)# show debug
Debug Logging
Destination:
Logging --
10.28.38.164
Facility=kern
Severity=warning
System module=all-pass
Enabled debug types:
event
Example:
In the following Example:, no syslog servers are configured on the switch (default setting). When you configure a
syslog server, debug logging is enabled to send Event Log messages to the server. To limit the Event Log
Chapter 13 Troubleshooting 515
To Next Page
Loading...
