HP Aruba JL253A - Ntp Authentication Key-ID

ntp authentication key-id <KEY-ID> [authentication-mode <MODE> key-value <KEY-
STRING>] [trusted]
Parameters/Options
key-id <id>
Sets the key-id for the authentication key.
Subcommands
authentication-mode
Sets the NTP authentication mode
key-value <KEY-STRING>
Sets the key-value for the authentication key.
[trusted]
Sets the authentication key as trusted.
Example
Switch(config)# ntp
Authentication Configure NTP authentication.
Switch(config)# ntp authentication
key-id Set the key-id for this authentication key.
Switch(config)# ntp authentication key-id
<1-4294967295> Set the authentication key-id.
Switch(config)# ntp authentication key-id 1
authentication-mode Set the NTP authentication mode.
trusted Set this authentication key as trusted.
Switch(config)# ntp authentication key-id 1
authentication-mode|trusted md5
Authenticate using MD5.
Switch(config)# ntp authentication key-id 1
authentication-mode|trusted md5key-value Set the NTP authentication key.
Switch(config)# ntp authentication key-id 1
authentication-mode|trusted md5 key-value
KEY Enter a string to be set as the NTP authentication key.
ntp authentication key-id
Syntax
ntp authentication key-id
<key-id> [authentication-mode [md5 | sha1]
key-value <key-value>] [trusted]
52 Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08