<MEMBER-ID>
The VSF member-ID for the member command or parameter. Member ID value can be in the range from 1 to
8.
erase fdr-log vsf
Erase FDR log from the specified member.
Syntax
erase fdr-log [vsf member <MEMBER-ID>] [slot | mm-active]
Description
Erase the FDR log files.
Parameters
<MEMBER-ID>
The VSF member-ID for the member command or parameter. Member ID value can be in the range from 1 to
8.
copy crash-files
Syntax
copy crash-files vsf member <MEMBER-ID> [<SLOT-ID-RANGE> | mm-active sftp | tftp |
usb | xmodem] <HOST-NAME-STR> | <IP-ADDR> | <IPV6-ADDR> <FILENAME-STR>
Description
Copy the switch crash files from the specific VSF member
Parameters
mm-active
Copy active management module crash files.
<MEMBER-ID>
The VSF member-ID for the member command or parameter. Member ID value can be in the range from 1 to
8.
<SLOT-ID-RANGE>
Enter single slot identifier.
Usage
Switch(config)# copy crash-files vsf member
Switch(config)# copy crash-files vsf member 1
VSF configuration
There are two methods to configure VSF for a switch:
• Manual configuration. See Manual configuration of a VSF.
• Automatic configuration. See Automatic configuration of a VSF fabric.
688 Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08
To Next Page
Loading...
