Auto-configured tunnel interface before creating IPsec. The tunnel ID is auto generated and to avoid conflict with
user generated tunnel interface, the tunnel id is always the max tunnel supported by the switch + 1.
aruba-vpn
Display the configuration and status details of aruba-vpn tunnel.
brief
Display brief configuration and status for all tunnels.
Usage
show interfaces tunnel aruba-vpn
show interfaces tunnel brief
show interfaces [tunnel] [<TUNNEL-LIST> | <TUNNEL-NAME> | brief | type]
switch(config)# show interfaces tunnel aruba-vpn
Tunnel Configuration :
Tunnel : tunnel-129
Tunnel Name : aruba-vpn-tunnel
Tunnel Status : Enabled
Source Address : 192.168.20.10
Destination Address : 171.0.0.3
Mode : IPsec IPv4
TOS : Value from IPv4 header
TTL : 64
IPv6 : Disabled
MTU : 1280
Current Tunnel Status :
Tunnel State : Up
Destination Address Route : 0.0.0.0/0
Next Hop IP : 192.168.20.31
Next Hop Interface : vlan-1
Next Hop IP Link Status : Up
Source Address : Configured on vlan-1
IP Datagrams Received : 11
IP Datagrams Transmitted : 36
switch(config)# show interfaces tunnel brief
Status - Tunnel Information Brief
Tunnel : tunnel-129
Mode : IPsec IPv4
Source Address : 192.168.20.10
Destination Address : 171.0.0.3
Configured Tunnel Status : Enabled
Current Tunnel State : Up
show crypto-ipsec sa
Syntax
show crypto ipsec sa
Description
322 Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08
To Next Page
Loading...
