HP Aruba JL253A - Show Cpu; Show Vsf Trunk-Designated-Forwarder

6/8 Up Member
7/8 Up Member
8/8 Up Member
If a MAD VLAN is not configured:
Switch(config)# show vsf vlan-mad
MAD VLAN is not configured
Switch(config)#
show vsf trunk-designated-forwarder
Syntax
show vsf trunk-designated-forwarder member <MEMBER-ID>
Description
Show the designated forwarders for each trunk.
Parameters
<MEMBER-ID>
The VSF member-ID for the member command or parameter. Member ID value can be in the range of 1 to 8.
Example
Switch# show vsf trunk-designated-forwarder member 1
Trunk Designated Forwarders
NAME TYPE Forwarding Member (Flood) Forwarding Member (Unicast)
----- ----- ------------------------- ---------------------------
Trk1 TRK 2 1, 2
Trk2 TRK 3 3, 4
show cpu
Syntax
show cpu <SECONDS>
Description
Show average CPU utilization.
Usage
show cpu slot <SLOT-LIST> [<SECONDS>]
show cpu process [slot <SLOT-LIST>] [refresh <COUNT>]
Example output
switch(config)# show cpu slot all
VSF slot 1/a:
-------------
42 percent busy, from 300 sec ago
1 sec ave: 37 percent busy
5 sec ave: 36 percent busy
1 min ave: 49 percent busy
VSF slot 2/a:
-------------
Chapter 20 Virtual Switching Framework (VSF) 675