WebAgent status information
The WebAgent Status screen provides an overview of the status of the switch. Scroll down to view more details.
For information about this screen, click on ? in the upper right corner of the WebAgent screen. For an Example: of
a status screen, see Figure 47: Example: of a WebAgent status screen on page 392.
Figure 47: Example: of a WebAgent status screen
Compatibility mode for v2 zl and zl modules
In the following context, v2 zl modules are the second version of the current zl modules.
Compatibility Mode allows the inter-operation of v2 zl modules with zl modules in a chassis switch. When in
Compatibility Mode, the switch accepts either v2 zl or zl modules. The default is Compatibility Mode enabled. If
Compatibility Mode is disabled by executing the no allow-v1-modules command, the switch will only power
up v2 zl modules.
allow-v1-modules
Syntax
[no] allow-v1-modules
Enables Compatibility Mode for interoperation of v2 zl and zl modules in the same chassis. (See Figure 48:
Enabling compatibility mode on page 392.) The no form of the command disables Compatibility Mode. Only
the v2 zl modules are powered up. (See Figure 49: Disabling compatibility mode on page 393.) Defaults to
enabled.
allow-v1–modules
Figure 48: Enabling compatibility mode
392 Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08
To Next Page
Loading...
