sntp broadcast
sntp 50
sntp authentication
sntp server priority 1 10.10.10.2.3 key-id 55
sntp server priority 2 fe80::200:24ff:fec8:4ca8 4 key-id 55
NOTE: SNTP authentication has been enabled and a key-id of 55 has been created.
In this Example:, the include-credentials command has not been executed and is not present in the
configuration file. The configuration file is subsequently saved to a TFTP server for later use. The SNTP
authentication information is not saved and is not present in the retrieved configuration files, as shown in the
following Example:.
Retrieved configuration file when include credentials is not configured
switch(config) # copy tftp startup-config 10.2.3.44 config1
.
.
.
Switch reboots ...
.
Startup configuration
.
.
.
timesync sntp
sntp broadcast
sntp 50 sntp server priority 1 10.10.10.2.3
sntp server priority 2 fe80::200:24ff:fec8:4ca8 4
.
.
.
NOTE: The SNTP authentication line and the Key-ids are not displayed. You must reconfigure SNTP
authentication.
Chapter 2 Time Protocols 47
To Next Page
Loading...
