Parameters and options
[ethernet] PORT-LIST
Specify the ports being configured for Ipv6 source-lockdown.
source-lockdown
Enable IPv6 source lockdown for a specific port.
Validation rules
Validation Error/Warning/Prompt
Verify whether dhcpv6-snooping is enabled
globally
DHCPv6 snooping is disabled.
Verify whether port configured is in the VLAN
which is dhcpv6-snooping enabled.
Ports <PORT-LIST> are not in a DHCPv6
Snooping VLAN.
If lockdown is being configured on a trusted port Port %s is a trusted port.
If the HW resources are not available for changing
dipv6ld global or a port characteristic
Cannot enable DIPLDv6 as required resources are
unavailable.
If global GVRP is enabled DIPLDv6 cannot be enabled when GVRP is
enabled
If no of snooped VLAN count is greater than
max_vlans_with_dipv6ld
DHCPv6 snooping cannot be enabled on %s
VLANs. The switch support only 8 DhCPv6
snooping enabled VLANs when Dynamic Ipv6
lockdown is enabled.
If Binding limits are exceeded Cannot enable Dynamic Ipv6 Lockdown on ports
%s as manual binding limits are exceeded.
If lockdown is being enabled on an interface which
is part of a dynamic trunk (LACP)
Cannot configure Dynamic Ipv6 Lockdown on
interface %s, it is a Dynamic trunk.
If lock down is being configured on a mesh port Cannot configure Dynamic Ipv6 Lockdown on a
logical mesh port.
If trunk is being formed using a port which has
DIPLDv6 enabled on it.
Cannot add a port to a trunk group when Dynamic
IPv6 Lockdown is enabled on that port.
If DIPLDv6 is configured on a trunk and the trunk
is being removed.
Cannot remove the port %s from the trunk group
because Dynamic IPv6 Lockdown is configured on
the trunk and removing the port will delete the
trunk.
If DIPLDv6 is being is configured on a Smart Link
port
Cannot enable Dynamic IPv6 Lockdown feature on
a Smart Link port.
If Smart Link is being enabled on a DIPLDv6
enabled port
Cannot configure the Smart Link feature on a port
when the Dynamic IPv6 Lockdown feature is
enabled on that port.
Chapter 9 DHCPv6 server 279
To Next Page
Loading...
